FREE SHIPPING WHEN YOU SPEND OVER $150

AFTERPAY. SHOP NOW. PAY LATER. INTEREST FREE

PROUDLY AUSTRALIAN OWNED

Same day dispatch

Free delivery over $200

90 day return

Henna Instructions

PRE-HENNA:

  1. Remove any makeup on the skin with the Oil Makeup remover if the client is wearing makeup.
  2. If the client is make-up free, apply the Gel-Based Cleanser  and clean the skin with water and cotton rounds. This is recommended even if the client isn’t wearing makeup to cleanse the skin of any oil, dirt and debris.
  3. If suitable to the client’s skin, exfoliate the brow area with the Glance Brow Scrub to remove any build up of skin and allow for the best skin stain and colour development to the hair. Remove with water until the residue has completely been wiped away. Ensure that the exfoliation is not done in any areas that have had hair removal or will have hair removal, as not to cause any irritation in the skin.

 

HENNA APPLICATION:

  1. With the Measuring Spatula, take the desired amount of Henna powder and pour into your mixing dish. Mix 1:1 portion of the henna powder to the Fixator (developer). 
  2. Stir the product until the consistency it is completely smooth and grains are no longer visible. The product should have a creamy consistency. If needed, add more Fixator or Henna powder to achieve this consistency. 
  3. Let the product set for 1 minute prior to application.
  4. Once applied to the brows, allow the henna to develop until the desired depth and colour is achieved. The henna will only take 7 minutes to develop, however if wanting to achieve a darker colour it can be left on the brows for 10-15 minutes.

Please note: Henna can sometimes develop into a warm tone or show a very faint green colour. If this occurs, we recommend you wiping a small amount of the Glance Henna Fixator over the dry brows, once the henna has been removed properly with water. Leave the fixator on for approximately 30 seconds, or until you can visibly see the colour neutralising on the skin.

 

HENNA REMOVAL: 

  1. Remove the henna gently with a cotton round dampened in water.
  2. Gently wipe a small amount of the Glance fixtor (developer) over the brows, leave on for 30 seconds or until you see the colour begin to neutralise. 
  3. Use the Glance Henna Remover to remove more of the skin stain if needed. This can be especially useful if the front of the brows appear too bold, or the client finds the overall look of the henna a little dark. Fading the skin stain, will help the brow appear more natural, as it is the skin stain that usually makes the brows appear darker initially. 
  4. If needed, apply the Ultra Softening Epilation Cream to the skin to soothe and calm. 

  *Please bear in mind that although water can be mixed with the henna powder to develop, the recommended product to develop the henna is the Fixator.  Mixing water instead of fixator will result in the colour not being as pigmented and as deep on the hair and skin, and will take a longer duration to develop.

Colours are all customisable and up to 2 colours can be mixed to achieve the perfect skin stain and brow colour to achieve the desired look.

 

*Please bear in mind that although water can be mixed with the henna powder to develop, the recommended product to develop the henna is the Fixator.  Mixing water instead of fixator will result in the colour not being as pigmented and as deep on the hair and skin, and will take a longer duration to develop.

Colours are all customisable and can be mixed to achieve the perfect skin stain and brow colour to achieve the desired look.

Precautions: For external use only. Keep out of the reach of children and protected from light. If there is irritation, discontinue use and seek medical advice.